Tutorials
Welcome to the LungTank tutorial page dedicated to the assembly and use of LungTank mini diving cylinders. In this section, we will guide you through the steps of assembling our LungTank products and show you how to use them safely during your underwater adventures. Watch the videos below for detailed instructions and helpful tips.
THE HAND PUMP
VITAL INFORMATION REGARDING THE HAND PUMP:
It is crucial to be aware of the following guidelines when using the hand pump:
- Take regular short breaks of approximately 2.5 minutes to allow the pump to cool down.
- Ensure that the filling pressure does not exceed 3000 PSI / 200 BAR.
- Always rely on the pressure gauge located on the Lung Tank for accurate pressure readings.
Replacing Filters
VITAL FILTER INFORMATION:
Please take note of the following important details regarding the filters:
- It is recommended to replace the Large Filter, Small Filter, and Carbon Balls after every 5 tank fills.
- You can conveniently purchase replacement filters directly from our website.
Adjusting Airflow
IMPORTANT AIRFLOW INFO:
- When adjusting airflow, only tighten or loosen the nut by 1/8th of a full turn before testing and repeating if neccessary.
- To allow MORE airflow, turn the nut anticlockwise (loosen).
- To allow LESS airflow, turn the nut clockwise (tighten).
Compressor
IMPORTANT COMPRESSOR INFO:
- This video is a general guide, please refer to the manufacturers leaflet in the box.
- Do not fill above 3000 PSI/ 200 BAR.
- Always refer to the Tank pressure gauge.
- Do not let compresser exceed 80 Degrees Celsius.
- Only connect / disconnect power to compresser when the pump switch off (down).
- Always check the explosion proof valve before use.
- Allow compressor to cool for 2 minutes before & after every use.